MaxTech Plug & Play Internal Voice/FAX/Data/SVD Modem User Manual download pdf (Page 7)

2.4.2 Configuring in a Plug and Play System with-

out Windows 95

When this modem is installed in a Plug and Play

system without Windows 95, the computer's BIOS will

assign a COM port and IRQ line to the modem.

Proceed to Section 2.5, Software Installation/

Configuration.

2.5 Software Installation and Configuration

You are now ready to install and configure the

communication software. Refer to your software manual

for installation procedures.

We suggest the following communication param-

eters when you first use your data communication

software. Consult the software manual for information

on using these and other parameters/features.

57,600 bps; 8 data bits; no parity; 1 stop bit;

RTS/CTS flow control set to “on;” initialization

string: AT&F

We suggest that a “Generic Class 1” or “Ge-

neric Class 2” modem type should be selected in your

fax software, and a “Lucent” modem type should be

selected in your Voice software.

Note that your software must be configured to

communicate with the modem on the same COM port

and IRQ line used by the modem.

2.6 Using the Fax, Voice, SVD, and

Speakerphone Capabilities of the

Modem

Your modem has built-in advanced FAX, Voice,

SVD, and Full Duplex Speakerphone functions. Please

consult your FAX/Voice/SVD/Speakerphone software

manual about procedures on using these features.

Speakerphone functions require a correctly con-

figured sound card with attached microphone and

speaker.

Voice functions include recording and playback

of voice prompts (files). You may record or playback

voice with your modem by attaching a telephone to the

1 2 3 4 5 6 7 8 9 10 11 12 ... 22 23

No comments

MaxTech Plug & Play Internal Voice/FAX/Data/SVD Modem User Manual Page 7